Saving or loading a multi
55
The Save a Multi popup window will appear, where you can execute the save operation.
A Save field: Specifies how the programs and
samples included in the multi will be saved.
B Replace same files field: Specifies how
identically-named programs or samples exist-
ing in the save-destination will be handled.
8. Move the cursor to the Save field, and turn the [JOG] dial to select one of the following ways in
which the programs/samples will be saved.
WITH PROGRAMS & SAMPLES: The programs and samples included in the multi will be saved with it.
WITH PROGRAMS: The programs included in the multi will be saved with it. (Samples will not be saved.)
MULTI ONLY: Only the multi will be saved.
WITH NEW & MODIFIED: Of the programs/samples included in the multi, only those that were modified
after being saved or loaded will be saved.
9. If you selected WITH PROGRAMS & SAMPLES or WITH PROGRAMS in step 8, move the cursor
to the Replace same files field, and turn the [JOG] dial to select how the programs/samples will
be saved.
YES: Existing data will be overwritten.
NO: Identically-named data will not be saved.
10. To execute the Save operation, press the [F5] key (DO IT).
The multi will be saved in the folder you specified. If you selected other than MULTI ONLY in step 8, the
corresponding programs/samples will be saved as well.
Loading a multi
Here’s how to load a multi from a storage device.
1. Press the [LOAD] key.
The Load page will appear. Here you can load files that were saved on a storage device.
A Disk information: Indicates the MPC4000’s
internal storage device or an externally-con-
nected storage device that is currently selected
for operations.
B Disk field: Selects the storage device from
which the multi will be loaded.
C File list block: Displays the hierarchical
structure of the storage device you selected.
D View field: Selects the type of file that will be
displayed in the tree.
E Wave free field: Displays the available
amount of sample memory in the MPC4000.
F Sequence free field: Displays the available amount of memory in the sequencer section of the
MPC4000.
G CPU free field: Displays the available amount of data management memory in the MPC4000.
Hint: If the File Exists popup window appears when you press the [F5] key, an identically-named multi already
exists on the storage device. If this occurs, take one of the following actions.
Press the [F3] key (RENAME) and rename the multi.
Press the [F5] key (REPLACE) to overwrite the existing multi.
2
1
1
2
3
4
5
6
7
To Next Page
Loading...
