Basic effect operations
61
A Level field: Adjusts the signal level that is
output from each effect.
B Direct signal field: Selects whether the sig-
nal (unprocessed sound) from the parts that
select the corresponding FX bus will be sent to
the output jacks.
If this is on, the signal from the part(s) and the
signal processed by the effect will be mixed
immediately before the output jacks.
If this is off, the corresponding part(s) will be
muted, and only the signal processed by the
effect will be sent to the output jacks.
6. Move the cursor to the Direct signal field, and turn the [JOG] dial to switch the setting on/off as
appropriate.
If this is on, the signal from the part(s) and the signal processed by the effect will be mixed and output. Use
the Wet/Dry field of the effect parameter to adjust the mix balance of the direct sound and effect sound.
7. As necessary, move the cursor to the Level field and turn the [JOG] dial to adjust the signal level
that will be output from the effect.
8. Press the [F2] key (EDIT).
The Edit page will appear. This page displays the effect parameters for the currently selected effect.
9. Move the cursor to the Wet/Dry field, and turn the [JOG] dial to adjust the mix balance between
the direct sound and the effect sound.
The Wet/Dry field adjusts the mix balance of the signal that is sent directly from the part(s) (=Dry) and the
signal processed by the effect (=Wet). The appropriate setting for the Wet/Dry parameter will depend on the
effect type and on how you are using the effect.
• To mix the direct sound and effect sound immediately before the output jacks
In step 6, turn the Direct signal field on, and set the Wet/Dry field to 100/0 (effect sound=100%). Use this
method when you want an effect such as reverb or delay to be shared between multiple parts.
• To send only the effect sound directly from the effect to the output jacks
In step 6, turn the Direct signal field off, and set the Wet/Dry field to 100/0 (effect sound=100%). Use this
method when you want to apply compressor or distortion to only a specific part.
• To send the original sound + effect sound from the effect directly to the output jacks
In step 6, turn the Direct signal field off, and set the Wet/Dry field according to the type of effect and the
desired effect depth. Use this method when you want to apply an effect such as chorus to only a specific part.
Hint: Turn this field ON for effects that are normally mixed with the unprocessed sound, such as reverb or delay.
Turn this field OFF for effects that process the original sound itself, such as compressor or distortion.
Hint: For details on setting effect parameters, refer to the following section.
1 2
To Next Page
Loading...
