Akai MPC4000

Chapter 8—Recording and editing samples
68
The Sample mode Sample list page will appear. This page shows a list of the samples currently in memory.
A Tag field
B Sample field: Lists the names of the samples
currently in memory. Newly recorded samples
and samples that were edited after being
loaded or saved will have a * symbol dis-
played in front of their name.
The characters displayed at the right of the
sample name have the following significance.
ST...........Stereo sample
MN .........Monaural sample
LP...........Loop playback is ON
C Sampling rate/Bit field: Displays the sam-
pling rate/bit depth of each sample shown in
field
2.
D [F1] key (LIST): Accesses the sample list page from another page.
E [F2] key (TRIM/LP): Accesses the Trim/Loop page, where you can make trim and loop settings for a
sample.
F [F3] key (REGION): Accesses the Region page, where you can divide a sample into regions and edit
them.
G [F4] key (Q-FX): Accesses the Quick FX Resampling popup window, where you can apply effects to a
sample and resample it.
2. Press the [F2] key (TRIM/LP).
The Trim/Loop page will appear. In this page you can make trim and loop settings for each sample.
A Sample field: Selects the sample that will be
edited.
B Sampling rate/Bit field: Indicates the sam-
pling rate and bit depth of the sample shown in
1.
C View field: Selects the displayed waveform;
either LEFT (left channel only), RIGHT (right
channel only), or MIX (both channels mixed).
D Monitor field: Selects either SAMPLE, PRO-
GRAM, or MULTI as the unit for monitoring.
E Start field: Specifies the playback start point
of the sample in single-sample units.
FEND field: Specifies the playback end point of
the sample. By default, this is displayed in sin-
gle-sample units.
G Waveform display field (upper): Displays
the waveform of the entire sample.
H Lp start field: Specifies the loop start point
of the sample in single-sample units.
I Lp end field: Specifies the loop end point of
the sample. By default, this is displayed in
single-sample units.
J Play mode field: Selects the playback
method for the sample.
K Waveform display field (lower): Accord-
ing to the field currently selected in the dis-
play, this area displays the waveform before
and after the start point, the waveform before
and after the end point, or the waveform
before and after the loop start/end point.
1
456 7
2
3
16
4
27
3
5
8
K
LMNOPQ
J
9
Play mode=Loop
Play mode=No Loop or ONE SHOT
Start point
Start point End point
Loop start point
Loop end point