11
Knobs: Turn the knobs to control certain parameters, depending on MPD232’s current control
bank:
• Control Bank A: Turn the knobs to control Macros 1–8 of the primary device.
• Control Bank B: Turn the knobs to control the Pan knobs of the tracks. Each knob
corresponds to the track with the same number (e.g., Knob 1 controls the panning of
Track 1, Knob 2 controls the panning of Track 2, etc.).
• Control Bank C: Turn the knobs to control the Send for Effect Track 1 of the tracks. Each
knob corresponds to the track with the same number (e.g., Knob 1 controls the send
level of Track 1, Knob 2 controls the send level of Track 2, etc.).
Press Ctrl Bank to cycle through the control banks.
Faders: Move the faders to control certain parameters, depending on MPD232’s current
control bank:
• Control Bank A: Move the faders to control the first 8 macros of the current device.
• Control Bank B: Move the faders to control the Volume faders of the tracks. Each fader
corresponds to the track with the same number (e.g., Fader 1 controls the volume of
Track 1, Fader 2 controls the volume of Track 2, etc.).
• Control Bank C: Move the faders to control the Send for Effect Track 2 of the tracks.
Each fader corresponds to the track with the same number (e.g., Fader 1 controls the
send level of Track 1, Fader 2 controls the send level of Track 2, etc.).
Press Ctrl Bank to cycle through the control banks.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
