E-3
CAUTION!
THIS PRODUCT UTILIZES A LASER.
USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN
THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE. DO NOT OPEN
COVERS AND DO NOT REPAIR YOURSELF. REFER SERVICING TO QUALIFIED PERSONNEL.
CAUTION!
DO NOT INSTALL OR PLACE THIS UNIT IN A BOOKCASE, BUILT IN CABINET OR IN ANOTHER
CONFINED SPACE IN ORDER TO KEEP WELL VENTILATED CONDITION. ENSURE THAT CURTAINS
AND ANY OTHER MATERIALS DO NOT OBSTRUCT THE VENTILATION CONDITION TO PREVENT
RISK OF ELECTRIC SHOCK OR FIRE HAZARD DUE TO OVERHEATING.
CONNECTIONS
Speaker connections
• Connect the right speaker to terminal R, with the red wire to + and the black wire to –.
• Connect the left speaker to terminal L, with the red wire to + and the black wire to –.
AC POWER SUPPLY
• After all other connections have been made, connect the AC power cord to the wall outlet.
HEADPHONES SOCKET
• You can plug headphones into the PHONES socket if you want to listen in private. Ensure you set the
volume to a low to avoid damage to your hearing.
PRESET EQ EFFECTS
The quality of tone can be adjusted by the preset sound equalizer which has been set into 4 modes (JAZZ,
ROCK, CLASSIC, POP). By pressing the corresponding sound preset button you can choose one of your
favorite mode according to you music style.
AUDIO MUTE CONTROL
Press remote mute button to the LCD display “MUTE” indicator will light up on display.
TO CANCEL “MUTE”
Press remote “MUTE” button again, or volume up down button, the MUTE indicator goes out.
USING THE RESET BUTTON
This button is used to solve the problem as following symptom:
• When the window display does not display.
• When the unit does not operate normally.
– Use a pencil or ball-pen when you press the RESET button.
NOTES:
You can reset the preset memory also as below.
1. Unplug the power cord and then plug the power cord again.
2. Hold the VOL-DOWN” button and then press the “POWER” button within 5 seconds, then all memories
setting will be cleared.
English.pmd 3/22/2004, 3:00 PM3
To Next Page
Loading...