Akai VS-G205

20
Multi-speed playback
The multi-speed playback feature can be used to increase or
decrease the playback speed.
The tape speed can be increased up to 3, 5 and 7 times the
normal playback speed in the forward or reverse directions.
in the forward direction the speed can be reduced to 1/10 of
the normal speed,or a still picture can be achieved.
@ Press the remote control’s MULTI-SPEED PLAY © or ©
button repeatedly during playback until you reach the
speed that you want.
@ Press the play > button to resume normal playback.
Note:
® Slow motion playback will be cancelled after 5 minutes to
protect the video tape.
x7 Forward
S)
ip
®
x5 Forward
©
=e
®
x3 Forward
|
0
yy
®
1/10 Forward
Om ®
>
ome
x3 Reverse
O
=
®
x5 Reverse
S)
=
®
x7 Reverse
® : Press the MULTI-SPEED PLAY © button.
© : Press the MULTI-SPEED PLAY © button.
Quick finder (cue/review)
During playback the quick finder function can be used to vis-
ually locate any point on a recorded tape. During quick finder
playback the picture will go forwards or backwards rapidly.
Disturbances in the quick finder picture are normal and do not
indicate a problem with the VCR.
@ During any playback mode (play, still, slow, etc.) press
the fast forward (cue) >> or rewind (review) <4button.
There are two ways to operate the quick finder mode. One
way is to keep the button held down until you reach the part
that you want to watch, and when you release it playback
starts automatically. The second way is to press the button
quickly and when you reach the part that you want to watch,
press the play button.
Note:
© “CUE” or“REVIEW’ will appear on the FL display for about 4
seconds.
e You can switch directly between cue and review.
The index search feature uses index codes, that are
automatically added to the video tape when programmes are
recorded on the VCR (except recordings begun from the rec-
ording pause mode).
You can go directly to the beginning of any recorded section
that has an index code and you can skip as many index codes
as you like until you find the section that you want to watch (you
can skip up to 99 index codes).
@ Press the remote control’s index search forward >i or
reverse |€< button (during the stop or play mode).
For example, to go to the 4th index code from your starting
point (forward or reverse), press the button 4 times.
When the tape reaches the section that you select, play-
back will begin automatically.
Note:
e@ When the index search reverse button is pressed once in
the middle of a programme, playback will start from the be-
ginning of that programme.
¢ This feature will not operate with tapes that do not have
index codes.
During index search “SRCH” and the index number will be
displayed on the FL display.
e There must be more than one minute between index codes
for this mode to operate properly.
The tape counter is displayed during playback and shows the
elapsed time of the video tape (in hours, minutes and sec-
onds).
The tape counter will not count unrecorded spaces on the
tape.
Mi To reset the counter to zero, press the COUNTER
RESET button.
The tape counter will also be reset when a video tape is in-
serted in the VCR.