14
Instructions
Before you start washing
A Make sure the washer is stable
and level. If necessary, adjust the
adjustable leg to stabilise the
washer.
B Make sure the water inlet hoses
are properly installed.
C Plug the machine into a nearby
power point.
D Open the water taps.
E Make sure the drain hose is properly
installed. Hang the upper end of the
hose over the laundry sink or into a
drain spout.
F Before using the washing machine
for the first time, run a complete
cycle without laundry items. Select
the NORMAL program and run the
machine until the end of the program.
Normal usage
1. Before washing, remove any coins, keys and other hard items
from pockets. Close any zippers to prevent damaging your
clothes and the wash tub. Brush dirt and sand off clothes and
turn pockets inside out.
2. Sort your washing into appropriate loads: whites,
coloureds, cottons, delicates, heavily soiled, etc.
Place delicate items into a wash bag for protection.
On the back
Install
the drain
hose at a
height of
80-120cm
to prevent
water drain-
age and
overflowing
problems.
A
B
D
C
E
3. Put your washing in the machine, loading items uniformly
in the tub.
4. Add washing detergent (see opposite for details).
5. Press the POWER ON/OFF button.
6. Refer to the Program Selection Guide (opposite) and select a suitable wash
program. For the NORMAL and HEAVY DUTY programs, the machine will
automatically choose the correct water power and level, wash and spin time
and rinse type. For the CUSTOM and SOFT WASH programs, the machine will
automatically select the correct water level.
7. Close the lid and press the START/PAUSE button.
NOTE: If the washer lid is not closed properly, the washer will sound an alarm and
stop working before spinning.
To Next Page
Loading...
