- 49 -
VPN
This feature requires a separate license. You can read more details about the licensing later in this
manual.
This feature is used by connecting the SP1+ with the APS VPN server. After the license has been
activated and the APS VPN server is set up, you’ll need to fill out the same options here to be able to
use the VPN connection (see below).
Note 1: You can also configure these settings from the APS console for the unit.
Note 2: If you use the VPN option, the maximum number of sensors that can be used by the unit will
be reduced to 36 on F4 units (no limit on H7).
To Next Page
Loading...
