- 8 -
LED information for SP1+ units
Power/Ethernet Link - Sensor 1 - Sensor 2 - Sensor 3 - Sensor 4
The Power/Ethernet LED will become red if there’s no network connection, and blinking green
(according to LAN activity) when the connection is normal.
LEDs Status:
Power = Solid red when connected
Ethernet = Should be green and yellow blinking (when accessing the web UI) for good connection.
Sensor, Internal Temp Sensor & Dry Contact = Green connected & normal status.
Sensor & Temp Sensor = Slow blinking Warning status.
Sensor & Temp Sensor = Fast blinking or red critical and error status.
Reset button functions for SP1+ units
There are specific commands you can send to the unit by holding the Reset button for a specified
amount of time.
You will have to use something such as a ball point pen, or paper clip to be able to press Reset.
However, be careful not to damage the button by aggressively pushing it in. Gently depress the
button until you feel the button depress.
The reset button is located to the left of the Ethernet RJ-45 connector.
Commands:
To Next Page
Loading...
