Notes:
- When the Reset button is held for longer than 12 seconds (DB erase) and then released, the Sensor
Port 1 LED will give a visual indication of the state of database erase (the reboot and password reset
doesn’t have visual indication).
- When the button is held longer than 17 seconds (factory reset) and then released, these sensor port
LED will be blinking fast and alternate during the factory reset mode.
Setting up the unit’s IP address & troubleshooting connection issues
Important Note: The unit’s ship with the passwords enabled. The default log in for the web interface
is Username: admin Password: public
IMPORTANT UPDATE – The changes below on how to connect to the SP+ (H7 type only) units has
been implemented when upgrading or using firmware version v1.0.5824 or higher. This DOES NOT
apply to, or affect any F7 or H7 SP+ units already in the field or previously shipped when upgrading to
the v1.0.5824 firmware or higher.
Note: This will also not apply to the F4 type units (final firmware version supported is v1.0.5606).
Please follow the directions in this SP+ setup video or the image for first connecting your unit:
https://www.youtube.com/watch?v=OtrccRpm1cw
Important Note: If you do not have a DHCP server, or do not use DHCP then the unit will only try
DHCP for a few seconds, if there's no reply it will fall back to the default IP address of 192.168.0.100.
Then you can use the direct cross over cable connection to your laptop or PC. Or simply connect the
unit to your network switch and type in the default IP address above in your browser. This also
applies if you are using the SP+ F4 or F7 type units.
Please note: The example in the video above & below shows our SP1+ unit. These steps will be the
same for all SP+ (SP1+ & SPX+ H7) units shipped with firmware v1.0.5824 or higher.
To Next Page
Loading...
