5
Installation Instructions
Before using you r wine cooler
Remove the exterior and interior packaging
Check to be sure the following parts are included:
For SC-18SSA, (5) Five removable she lves.
Instruction manu al.
Before connecting the wine cooler to power source, let it stand u pright for approximately 2 hours.
This will reduce the possibility of a malfun ction in the cooling system from handling during
transportation.
Clean the interior surface with lukewarm water usin g a soft cloth.
Place your wine coo le r on floor strong enough to support the wine cooler when it is fully loaded.
To level your wine cooler, adjust the front legs at the botto m of the wine cooler.
Keep away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct su nlight
may affect the acrylic coating and heat sources may increase electrical c onsumption. Extreme cold
or hot ambient temperatures may also cause the wine coolers not to perform properly.
Not designed for placement in attic or basement. Designed for use inside the home.
Electrical Connection
This unit should be properly grounded for your safety. The power cord of this unit is equipped with a
3-prong plug which mates with 3-pron g wall outlets to minimize the possibility of electrical shock. Do
not under any circu mstances cut or remove the ground win e from the power cord supp lied.
Use of extension cords is not recommend ed.
This unit requires a standard 110V-60HZ electrical outlet with 3-prong plug.
The cord should be secured behind the wine cooler and not exposed or dangling
to prevent acc idental
injury.
Warning
Improper use of the grounded plug can resu lt in the risk of electrica l shock. If the power
cord is damaged, have it replaced by an authorized Products Service Center.
To Next Page
Loading...