AKUVOX SMART INTERCOM www.akuvox.com
Direct IP Call: tick the check box to enable the direct IP call. For example,
if you do not allow direct IP call to be made on the device, you can untick
the check box to terminate the function.
Direct IP Call Port: the direct IP Call Port is "5060" by default with the port
range from 1-65535. And you enter any values within the range other
than the 5060, you are required to check if the value entered is consistent
with the corresponding value on the device you wish to establish a data
transmission with.
11.2.SIP Call &SIP Call Configuration
You can make SIP call (Session Initiation Protocol) in the same way as you
do for making the IP calls on the device. However, SIP call parameters related
to its account, server, and transport type need to configured first before you
can make calls on the device.
11.3.SIP Account Registration
Akuvox X933/C319 series indoor monitors support two SIP accounts that
can all be registered according to your applications. For example, you can
switch between the two SIP accounts. The SIP account can be configured
on the device and on the device interface. To configure the SIP account on
the device Settings > Advance Settings > Account screen.
To Next Page
Loading...
Need help?
General
