Need help?Do you have a question about the Akw M DigiPumps Series and is the answer not in the manual?
Details specifications and contents for the AKW M11 DigiPump model.
Details specifications and contents for the AKW M17 DigiPump model.
Details specifications and contents for the AKW M20 DigiPump model.
Explains suitability for zones 1, 2, or 3 and placement rules.
Details unit placement, cable routing, and sealing requirements.
Illustrates wiring diagrams for electric and bar mixer showers.
States the appliance does not require an earth connection.
Details voltage, RCD, fuse requirements, and switching off power.
Instructions on using pump spacers to prevent cable trapping.
Guide to connecting an optional auxiliary switch to the pump.
Steps for removing the pump cover and accessing the back plate.
Guidance on marking holes, drilling, and mounting the pump securely.
Procedure for reversing the pump head housing to set flow direction.
Instructions for fitting non-return valves and pump connectors.
Advice on locating pump and minimizing pipework for optimal performance.
Illustrates preferred and non-preferred plumbing connection methods.
Importance of securing pipework to prevent vibration and using clips.
Guidance on installing filters and sensors for electric and mixer showers.
Ensuring correct flow direction and sensor accessibility for maintenance.
Diagrams showing correct installation for vertical and horizontal water feeds.
Reiteration of sensor/filter accessibility and dry location for cables.
Details for connecting sensors for mixer showers and handling for electric showers.
Illustrates wiring connections for flow sensor to pump via connector block.
Explanation of the functions of the RUN, TEST, and DELAY buttons.
Information on accepted sensor types and the calibration process.
Details on auxiliary switch types and the start delay function.
Explanation of the run-on time feature for clearing water.
Describes standby mode and display indicators for pump models.
Steps for adjusting sensor type and calibration values via buttons.
How to adjust start delay and run-on time settings.
Procedure for testing the pump in test mode.
Emphasizes flushing pipework before installing the flow sensor.
Steps for installing the pump and checking push-fit connections.
Guide for checking pump operation, calibration, and run-on settings.
Recommends quarterly checks of case integrity and RCD operation.
Specifies clearance needed for pump removal during maintenance.
Guidance on cleaning the unit and avoiding harsh cleaning agents.
Addresses issues with the pump display not showing lights.
Solutions for the pump not starting when the shower is turned on.
Troubleshooting steps for the pump running but not drawing water.
Troubleshooting for the pump not removing enough water from the shower.
Checks for damage or blockages in pump head and non-return valves.
Addresses issues where the pump operates with excessive noise.
Solutions for water remaining in the shower tray after the shower is turned off.
Explains causes for water remaining in the tray after a period.
Explains how to validate warranty and what it covers.
Lists items and conditions not covered by the warranty.
Advice on regular servicing intervals and hard water areas.
Outlines three methods to activate the product warranty.
Provides contact details for orders, general, and technical enquiries.
Lists the company's physical address and official website.
General| Brand | Akw |
|---|---|
| Model | M DigiPumps Series |
| Category | Plumbing Product |
| Language | English |
To Next Page
