Colour: White to RAL 90 Internal Building use only
Patent GB 2375479
Installer: Please ensure that this information is left
with the end user of this pr
oduct.
Assembled
Remove
for cleaning
ALWAYS read the installation instructions before installing
this product.
ALWAYS read the installation and end user care instructions.
ALWAYS match the correct waste to the shower base.
ALWAYS have the pumped waste installed by a trained
and experienced skilled craftsman.
NEVER use the pumped waste without the unit fully
assembled.
BEWARE A child finger trap may be present during the
handling or use of this product.
ALWAYS Keep fingers clear of the gaps between the cover,
and the locking ring.
DO NOT place matches or cigarettes on or near this product.
The following plastic materials are used in this
product: Acrylonitrile Butadiene Styrene (ABS),
Ethylene Propylene Thermoplastic Rubber (EPTR)
© 2007 AKW Medi-Care Limited 05-017-008-03
For further details on this and other AKW products please contact your distributor
- see details on outer packaging
The measurements throughout these installation and user care instructions have been converted from metric to its equivalent in imperial, therefore all
dimensions are approximate and subject to manufacturing tolerances. AKW MediCare does not make any warranty, expressed or implied, or accept any
liability in connection with this information or its use. This information is furnished upon the condition that the person receiving it shall make his/her own
tests to determine the suitability ther
eof for his/her particular purpose.
*John Guest and Speedfit are registered trade marks of John Guest International Limited
*Polypipe is a registered trademark of Polypipe plc, a subsidiary of IMI plc
15mm or 22mm PW50 Pumped Waste
Installation and user care instructions
AKW MediCare
To Next Page
Need help?
General
