General: 01905 823 298 | www.akw-ltd.co.uk6
6
IMPORTANT SAFETY & ELECTRICAL INFORMATION
Important Safety & Electrical Information
THIS CLASS II APPLIANCE DOES NOT REQUIRE AN EARTH
The 230V AC power supply to this unit must be provided via a two-pole isolator switch and a dedicated
circuit with a 30mA RCD device installed in accordance with the latest revision of the Wiring Regulations
BS7671. It must be wired into a fused, un-switched, xed wiring connector tted with a 5 amp fuse.
The IP45 rating of the AKW pump product refers to the inner casing containing the electrical control gear.
The pump motor which operates at SELV is located within the outer cover.
READ INSTRUCTIONS
BEFORE INSTALLING
THIS PRODUCT
READ INSTRUCTIONS
BEFORE INSTALLING
THIS PRODUCT
READ INSTRUCTIONS
BEFORE INSTALLING
THIS PRODUCT
CAUTION: 230V AC
Lethal Voltage present on the AC supply
Ensure mains power supply is switched OFF before starting wiring
DO NOT take risks with plumbing or electrical installation. This product must be installed and
serviced by a competent person in accordance with the current edition of the Wiring Regulations
(BS7671), local by-laws and the current building regulations.
This product must be installed, used and maintained in good working order in accordance with
these instructions and recommendations.
If the supply cord is damaged, it MUST be replaced in order to avoid hazard.
To Next Page
