EasyManua.ls Logo

AL-KO DIVE 5500/3 - User Manual

AL-KO DIVE 5500/3
120 pages
Go to English
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
477 275_a I 09/2013
DIVE 5500-3 DIVE6300-4
Betriebsanleitung

Table of Contents

Questions and Answers

  • O
    obaldwinAug 10, 2025
    Why AL-KO Water Pump motor does not run?
    • A
      alyssamartinAug 10, 2025
      If your AL-KO Water Pump motor isn't running, here are a few potential causes: * **No mains power:** Check the fuses and have the power supply inspected by a qualified electrician. * **Impeller blocked:** Remove any dirt in the suction area. Clean through the opening at the back of the motor housing using a suitable tool. * **Thermal protection switch has switched off:** Wait for the thermal protection switch on the immersion pump to switch back on. Be mindful of the maximum temperature of the conveying medium and have the pump inspected. * **Float switch does not switch off when the water level rises:** Send the immersion pump to an AL-KO service facility.
  • C
    Colleen ScottAug 19, 2025
    What to do if AL-KO DIVE 5500/3 is running but not feeding?
    • R
      richardsonnicoleAug 19, 2025
      If your AL-KO Water Pump is running but not feeding, consider these possibilities: * **Air in pump housing:** Vent the immersion pump by holding it at an angle. * **Blockage on the suction side:** Remove any dirt in the suction area. * **Pressure line closed off:** Open the pressure line. * **Pressure hose kinked:** Extend the pressure hose.
  • A
    Ann HensleyAug 29, 2025
    How to increase the feed rate of my AL-KO DIVE 5500/3?
    • E
      edwin17Aug 30, 2025
      If the feed rate of your AL-KO Water Pump is too low, check the following: * **Hose diameter too small:** Use a bigger pressure hose. * **Blockage on the suction side:** Remove any dirt in the suction area. * **Feed head too high:** Observe the maximum feed head specified in the technical data.

Summary

Translation of Original Operating Instructions

Function of the Pump

Designated Use

Possible Misuse

Scope of Delivery

Safety Instructions

Electrical Safety

Assembly

Mounting the Pressure Line

Startup

Startup Safety

Maintenance and Care

Troubleshooting

Motor Does Not Run

Troubleshooting steps for when the pump motor fails to start.

Pump Running But Does Not Feed

Solutions for when the pump operates but no liquid is delivered.

Feed Rate Too Low

Diagnosing and resolving issues with reduced pumping performance.

EU Declaration of Conformity

AL-KO DIVE 5500/3 Specifications

General IconGeneral
BrandAL-KO
ModelDIVE 5500/3
CategoryWater Pump
LanguageEnglish

Related product manuals