EasyManua.ls Logo

AL-KO DIVE 6500/34 - User Manual

AL-KO DIVE 6500/34
128 pages
Go to English
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
477275 DIVE 5600/34 | DIVE 6500/44
Deckblatt
BETRIEBSANLEITUNG
Tauchpumpe
DIVE 6500/34
DIVE 5600/44 Automatic
477275_f
04 | 2021
DE
GB
NL
FR
IT
SI
HR
RS
PL
CZ
SK
HU
DK
SE
FI
RO
RU
UA

Table of Contents

Questions and Answers

  • L
    Latoya FoxAug 12, 2025
    Why AL-KO DIVE 6500/34 motor does not run?
    • C
      Christina JonesAug 12, 2025
      If your AL-KO Water Pump motor isn't running, here are a few potential causes: * **No mains power:** Check the fuses and have the power supply inspected by a qualified electrician. * **Impeller blocked:** Remove any dirt in the suction area. Clean through the opening at the back of the motor housing using a suitable tool. * **Thermal protection switch has switched off:** Wait for the thermal protection switch on the immersion pump to switch back on. Be mindful of the maximum temperature of the conveying medium and have the pump inspected. * **Float switch does not switch off when the water level rises:** Send the immersion pump to an AL-KO service facility.
  • J
    Jeffrey SanchezAug 20, 2025
    What to do if AL-KO DIVE 6500/34 Water Pump is running but not feeding?
    • C
      Carrie OlsonAug 21, 2025
      If your AL-KO Water Pump is running but not feeding, consider these possibilities: * **Air in pump housing:** Vent the immersion pump by holding it at an angle. * **Blockage on the suction side:** Remove any dirt in the suction area. * **Pressure line closed off:** Open the pressure line. * **Pressure hose kinked:** Extend the pressure hose.
  • V
    Virginia TurnerAug 30, 2025
    How to increase the feed rate of my AL-KO DIVE 6500/34 Water Pump?
    • T
      Tiffany RyanAug 30, 2025
      If the feed rate of your AL-KO Water Pump is too low, check the following: * **Hose diameter too small:** Use a bigger pressure hose. * **Blockage on the suction side:** Remove any dirt in the suction area. * **Feed head too high:** Observe the maximum feed head specified in the technical data.

AL-KO DIVE 6500/34 Specifications

General IconGeneral
Max Head34 m
Max Immersion Depth7 m
Cable Length10 m
Voltage230 V
Frequency50 Hz
Impeller MaterialNoryl
Max Flow Rate6500 l/h
Inlet/Outlet SizeG 1 1/4
Pump Diameter180 mm
Outlet DiameterG 1 1/4

Related product manuals