Why AL-KO Trimmer smokes excessively?
Excessive smoke in your AL-KO Trimmer can be due to an incorrect fuel mixture or an improperly adjusted carburetor. Ensure you are using the correct fuel mixture (25:1). If the problem persists, have the carburetor adjusted by an Authorized Service Centre.
What to do if AL-KO FRS 410 Trimmer unit won’t start?
If your AL-KO Trimmer doesn't start, it could be due to several reasons. First, ensure you are following the correct starting procedures as outlined in the User Manual. Other potential causes include a fouled spark plug, which should be cleaned, gapped, or replaced, a plugged fuel filter, which should be replaced and an incorrect carburettor mixture adjustment setting, which requires adjustment by an Authorized Service Centre.
Why AL-KO FRS 410 Trimmer starts, but engine has low power?
If your AL-KO Trimmer starts but the engine lacks power, check the choke lever position and ensure it is in the RUN position. A dirty air filter can also cause this issue; remove, clean, and reinstall the filter. If these steps don't resolve the problem, the carburettor mixture adjustment setting may be incorrect, and you should have it adjusted by an Authorized Service Centre.
What to do if AL-KO Trimmer has no power under load?
If your AL-KO Trimmer has no power under load and runs erratically, the spark plug gap may be incorrect. Clean, gap, or replace the spark plug.
Why AL-KO FRS 410 Trimmer engine hesitates?
If the engine of your AL-KO Trimmer hesitates, the carburettor mixture adjustment setting may be incorrect. Have the carburettor adjusted by an Authorized Service Centre.
Safety guidelines for using the petrol power scythe.
Essential checks and preparations before operation.
Proper techniques and precautions for operating the unit.
Interpretation of safety symbols used in the manual.
Prohibited actions and misuse to avoid.
Identification of machine parts and their labels.
Step-by-step guide for attaching the "D" handle.
Step-by-step guide for attaching the "Bike" handle.
Instructions for fitting the protective guard hood.
Steps for installing the cutting head and blade.
How to adjust the cutting height for optimal use.
Correct fuel and oil ratios for 2-stroke engines.
Detailed steps for starting the engine.
Specific instructions for starting a cold or warm engine.
Method for safely shutting down the engine.
Further safety advice before and during trimming.
How to extend the trimmer line.
Techniques for various trimming tasks.
Guidelines for using cutting blades safely.
Steps for cleaning or replacing the air filter.
Information on carburetor adjustment.
How to check and maintain the spark plug.
Instructions for sharpening the debris shield knife.
Safety guidelines for using the petrol power scythe.
Essential checks and preparations before operation.
Proper techniques and precautions for operating the unit.
Interpretation of safety symbols used in the manual.
Prohibited actions and misuse to avoid.
Identification of machine parts and their labels.
Step-by-step guide for attaching the "D" handle.
Step-by-step guide for attaching the "Bike" handle.
Instructions for fitting the protective guard hood.
Steps for installing the cutting head and blade.
How to adjust the cutting height for optimal use.
Correct fuel and oil ratios for 2-stroke engines.
Detailed steps for starting the engine.
Specific instructions for starting a cold or warm engine.
Method for safely shutting down the engine.
Further safety advice before and during trimming.
How to extend the trimmer line.
Techniques for various trimming tasks.
Guidelines for using cutting blades safely.
Steps for cleaning or replacing the air filter.
Information on carburetor adjustment.
How to check and maintain the spark plug.
Instructions for sharpening the debris shield knife.
General| Power type | Petrol |
|---|---|
| Engine displacement | 32.6 cc |
| Cutting width | 410 mm |
| Engine Type | 2-stroke |
| Shaft Type | Straight |
| Handle Type | Bike handle |
| Cutting System | Nylon line and blade |
| Fuel Tank Capacity | 0.7 L |
To Next Page
