ALADDIN BLUE F
LAME
HEATER
Before using the heater you should remove a
ll
cardboard packing pieces, etc. which have been
used
to
protect the heater during transit. Release
spring clip (H.208) so that the whole
of
the top
of
the heater can be lowered
to
expose the bume
r.
Remove the packing. Close the top
of
the heater
and make sure that the spring clip engages fully
with the catch before carrying.
Unscrew filler cap
(H
.
216)
which will be found on
the top
of
the
tank
(H.213) exactly opposite the
wick winder
'W'
and
fill
the tank, which will hold
one gallon ( 4.5 litres), with best quality kerosine
(paraffin). We recommend ALADDIN
PINK
PARAFFIN
(available in U.K. and Eire).
Don't
u
se
vaporising oil
or
power kerosine. NEVER
USE motor fuel (Gasolene, Benzine, Essence,
etc.)
or
other dangerous fuel
s.
Replace filler cap
and wipe the top
of
the tank clean. When lighting
for the first time, or when a new wick
(H.210) has
been fitted, leave the heater unlit for an hour so
that the wick can become thoroughly soaked.
This heater
will
run for
at
least
16
hours on a
filling.
Do
not
bum
the heater dry. The oil
gauge (H.217) will show when the
tank
is ap-
proximately (a) full, (b)
~
full
,
(c)
t full, (d) t
full,
(e)
empty (see
fig.
2)
.
II
..
(a)
--
(b)
~
(c)
-=>
(d)
C)
(e)
UNPACKING
TO
FILL
To Next Page
Loading...
