3. Turn on the BeHear PROXY
neck speaker by sliding up
the Power button and holding
it until the unit vibrates and
the LED turns light blue.
A voice prompt will be played.
Verify that the mode
switch is set to
Loudspeaker position.
4. Successful connection of the BeHear PROXY is indicated
by the illuminated A on the HearLink PLUS panel.
The LL is illuminated to indicate that the Low Latency
APTX-LL Bluetooth CODEC is being used.
LL
A
If the automatic connection is delayed, briefly shift
up the BeHear PROXY Power button to reconnect it
to the HearLink PLUS transmitter.
3
To Next Page
Loading...