Hard drive installation instructions for the ADC-CSVR2000P/2008P/
2016P
Install or replace a failed drive in the ADC-CSVR2000P/2008P/2016P
Important: Install the serial advanced technology attachment (SATA) hard drives before enrolling the device. The
CSVR supports most standard SATA hard drives. SATA hard drives are user-supplied.
To install new hard drives
1. Verify that the device has no power and is unplugged.
2. Using a screwdriver, remove the screws on the sides and back of the chassis.
3. Remove the top cover of the chassis.
4. Connect the SATA power cable and SATA data cables to the main board.
5. Connect the SATA power cable and SATA data cables to the new hard drives. When installing hard drives, the
label sides should be facing up.
6. Align the bottom of the hard drives along the bottom of the enclosure. The connector sides should be facing
towards the center of the chassis.
7. Using a screwdriver, install screws from the bottom of the chassis to secure the hard drives in place.
https://answers.alarm.com/Partner/Installation_and_Troubleshooting/Video_Devices/Commercial_Stream_Video_Recorder_(…
Updated: Thu, 14 Apr 2022 20:22:51 GMT
1
To Next Page
Need help?
General
