ADC-V722W Installation Guide 3
AP Mode
Add the Camera to an Alarm.com Account
To ensure sufficient Wi-Fi signal, complete these steps with the
camera near its final location but prior to mounting.
1 Connect the camera’s AC power adapter and plug it into a non-
switched outlet.
2 Hold down the WPS button and release when the LED begins to
flash white (about 6 seconds).
3 On an Internet enabled device, connect to the wireless network
“ALARM (XX:XX:XX)” where XX:XX:XX is the last six digits
of the ADC-V722W’s MAC address, which is located on the
back of the ADC-V722W.
4 On the same device, open a web browser and enter
“http://722winstall” in the URL field. Follow the on-screen
instructions to add the ADC-V722W to the wireless network. The
LED will be solid green when the connection is complete.
5 Add the device to the account by either selecting the account in
MobileTech OR by using a web browser and entering the following
URL: www.alarm.com/addcamera
6 Select the camera from the video device list or type in its MAC
address to begin adding the camera. The camera’s MAC address is
located on the back of the camera.
7 Follow the on-screen instructions to finish adding the camera.
You may configure camera settings from the Customer Website.
You can now power down the camera and install it in its final location
using the included hardware.
To Next Page
Loading...
Need help?
General
