Alarm.Com ADC-V722W - Wireless Connection Methods; WPS Mode Enrollment Steps; AP Mode Enrollment Steps; Factory Reset and Recovery

ADC-V722W Installation Guide 5
Wireless Enrollment
Flashing Blue | WPS Mode
To enter WPS mode, push the WPS button and release when flashing
blue (about 3 seconds). See instructions above to add the camera to
your router and account using WPS.
Flashing White | AP Mode
To enter AP mode, push the WPS button and release when flashing
white (about 6 seconds). See instructions above to add the camera to
your router and account using AP mode.
Factory Reset
Flashing Green & Red | Factory Reset
WARNING: This will restore factory-default settings to the camera.
If already installed, the camera may need to be removed from the
Alarm.com account and re-added after a factory reset. To perform a
factory reset, push the WPS button and release when flashing Green
and Red (about 15 seconds).