27
English
3.1. Installing the DAB+ antenna
1. Use a damp cloth to clean the windscreen.
2. Stick the black L-shaped copper lm to the A-pillar (without
trim) of the vehicle.
3. Remove the adhesive protective lm of the antenna amplier
and stick it to the intended position on the windscreen.
4. Now stick on the lm antenna. Remove air bubbles by
applying light pressure to the edge.
5. The antenna should be mounted vertically and not
horizontally.
6. Route the antenna cable along the A-pillar up to where the
DR 56+ is to be installed.
7. Do not attach the DAB antenna over heating wires, at a
location where the driver's view is impaired, or in a place
where the windscreen is metallized (sun protection). This
could adversely affect the reception.
8. Alternatively, the antenna can also be mounted on the rear
window.
To Next Page
Loading...
