22
channels. You can program one stored channel in each
bank as a priority channel (3 channels for total).
If the priority feature is turned on, as the scanner scans the
bank, it checks that bank's priority channel for activity every
2 seconds.
The scanner automatically designates each bank's first
channel as its priority channel.
Follow these steps to select a different channel in a bank as
the priority channel.
• Manually select the channel you want to select as
the priority channel.
• Press FNC + PRI for two seconds. P appears
above the selected channel number.
Repeat these steps for the channel in each bank you want to
program as a priority channel.
Note: If all priority channel should be locked out, the display
will show error message All Loc. In such cases unlock at
least some of the channels.
Monitor
• While pressing and holding MON, Monitor Mode
is turned on, Squelch is open.
• To exit Monitor Mode, release MON.
Using Keylock
Use the scanner's keylock to protect it from accidental
program changes. When the scanner's keys are locked, the
only controls that operate are
, PWR, FNC, MON,
LIGHT and RSM/HOLD.
• To turn on keylock, press FNC +
• To turn off keylock, press FNC +
again.
The display shows the
symbol as long the keyboard is
blocked.
Note: Using keylock does not prevent the scanner from
scanning channels, when scanning had been started before
locking the keys.
Using the Display Backlight
• To turn on the display light for easy viewing at
night, press FNC + LIGHT. The display lights for
15 seconds.
• To turn off the light sooner, press FNC +LIGHT
again.
Information about “Birdies”
To Next Page
Loading...
