2. Shortly press microphone [UP] or [DN] to change ASQ level
3. Hold microphone [UP] or [DN] to change the ASQ level fast fast.
4. Hold [SQ] or wait for 3 seconds to store and exit.
Note: Higher ASQ level require a stronger signal to open the speaker and hear the
calling.
4.6 Modulation Type
1. Shortly press [A/F] key to switch between AM /FM mode.
2. The LCD displays the selected mode.
4.7 RF Gain control
1. Shortly press [RFG] key, LCD displays R and the present RF gain level flashes.
2. Shortly press microphone [UP] or [DN] to change the level of attenuation.
3. Shortly press [RFG] key to exit RF gain level control.
Note: When RFG function is on, the LCD displays “R”, if RFG level 6 is selected it
means the attenuation is 6 dB
4.8 Emergency Channel
1. Shortly press [EMG] key to choose CH9, the channel number flashes.
2. Shortly press [EMG] key again to choose CH19, the channel number flashes.
3. Shortly press [EMG] key third time to return to last normal channel.
4.9 Key Lock
1. Hold [EMG] key for over 2 seconds to lock the keys, LCD displays "LC".
2. Hold [EMG] key for over 2 seconds again to unlock the keys, LCD displays OF.
Note: In lock Mode, all keys except PTT are valid.
4.10 Scan function
1. Hold [A/F] to start scan function, “SC” flashes in the LCD.
2. Press microphone [UP] or [DN] to change scan direction during scan.
3. Press [A/F] or [PTT] key to exit scan function.
4.11 Changing the CB-Standard
1. Hold [A/F] while powering the radio on, until LCD displays the norms.
2. Press microphone [UP] or [DN] to choose wanted norms.
3. Power off and power on again
To Next Page
Loading...
