Alcatel-Lucent 4038 - Deleting an Accessory (Headset, Handset, Etc.): Bluetooth Wireless Technology; Use of the Bluetooth Handset

Programming your telephone
31
7
7.22
Use of the Bluetooth® handset (Alcatel-Lucent IP Touch 4068 Phone)
7.23
Installing a Bluetooth® Wireless Technology headset (matching)
- Alcatel-Lucent IP Touch 4068 Phone
Before a Bluetooth® headset can be used, it must be correctly matched to the terminal. Before performing the matching
operation, the headset must be in detectable mode*.
searching for Bluetooth® equipment,
wait until the detected equipment
type and the address is displayed
select the
relevant
equipment
the 3 note audible signal indicates that the handset has
been installed correctly (the LED flashes green or orange
depending on the battery charge level)
Add
reach the 'Menu'
page
menu
10:30
Settings
Phone
Bluetooth
* Refer to the user documentation supplied with the headset.
7.24
Using a Bluetooth® Wireless Technology headset - Alcatel-Lucent IP
Touch 4068 Phone
Refer to the user documentation supplied with the headset.
7.25
Deleting an accessory (headset, handset, etc.): Bluetooth®
Wireless Technology
searching for Bluetooth® equipment,
wait until the detected equipment
type and the address is displayed
select the relevant
equipment
acknowledgement message
and display of the headset
icon on the terminal screen
apply your choice enter the PIN
code of the
headset *
Add device
Add
2
6
5
3
ab c
def
jkl
m
no
display of the different equipment
matched
select the equipment
to be removed
message acknowledging the
equipment has been removed
apply your choice
menu
10:30
Settings
Phone
Bluetooth
My devices
Remove dvc
• Error messages
the Bluetooth® handset emits a
sequence of 4 beeps
The generation of your station is
earlier than the generation of your
Bluetooth® handset
The station displays an error
message indicating an
incompatibility between the
station and the Bluetooth®
handset
The generation of your
Bluetooth® handset is earlier than
the generation of your station
The Bluetooth® cordless handset permits the user to answer and converse with complete freedom within a radius of 10 meter
from the set.
• Green flashing: normal operation.
•Green steady: handset charging.
• Orange flashing: battery charge low or handset outside coverage zone.
• Orange steady: malfunction.
• Off-hook/On-hook and Volume/Mute keys
Off-hook/On-hook: press this key to take or
terminate a call.
Volume/Mute:
• short successive presses to change the
handset volume level (3 levels)
• long press to ensure your correspondent no
longer hears you
If the Bluetooth® handset is on its base, you do not need to press the Off-hook/On-
hook key to take or terminate the call. Just off-hook/on-hook the Bluetooth® handset.
The handset has a LED and two buttons.
• Light