Alcatel-Lucent Halo H3P - Page 108

Copyright @ALE 2020 All Rights Reserved
108
Call Display is used in phone ringing, calling process, hold and other scenarios. This function is
mainly used by users to configure the full name display method according to their own habits.
There are two main configuration items, defined as CallDisplayPart and CallDisplaySource.
➢ CallDisplayPart is used to define the call information display mode.
➢ CallDisplaySource is used to display the priority of the call number.
The following table lists the parameters you can use to configure call display.
Parameter
CallDisplayPart
config.<mac>.xml
Description
It configures Call Display Part.
Permitted
Values
0: Name Number
1: Number Name
2: Name
3: Number
4: Full Contact Info
Default
0
Web UI
Setting->Call Display-> Call Info Display Mode
Parameter
CallDisplaySource
config.<mac>.xml
Description
It configures Call Display Source.
Permitted
Values
0 - Local Directory>Remote Phone Book>LDAP Directory>Network signaling
1 - Network signaling
Default
0
This feature is used to control the popup of new voicemail and missed call.
➢ If the VMPopupEnable is set to true, the notification of voice mail and missed call will be
popup when sip phone miss an incoming call or receive a voicemail.
➢ If the VMPopupEnable is set to false, the notification of voice mail and missed call will not
be popup when sip phone miss an incoming call or receive a voicemail.
The following table lists the parameters you can use to configure notification popups.
Parameter
VMPopupEnable
config.<mac>.xml
Description
It configures to enable of disable the popup of voicemail and missed call.
Permitted
Values
false
true
Default
true
In Halo R120 release, when the user uses an input method other than 123 (eg :abc ABC Abc 2ab…).
The phone provides an input field to prompt the user for the current input character and displays the
next few characters.