This chapter provides basic instructions for setting up your IP phones with a provisioning server.
In Halo R120 release, H3P/H3G/H6/H3W/H6W phones support TFTP, HTTP and HTTPS protocols
to download configuration files and binary files.
Topics
WBM
Phone MMI
Common configuration file, Device Specific configuration file
EDS (Easy Deployment Server)
Provisioning Methods
You can configure IP phones via web user interface, a web-based interface that is especially useful
for remote configuration.
Because features and configurations vary by phone models and firmware versions, options
available on each page of the web user interface can vary as well. Note that the features
configured via web user interface are limited. Therefore, you can use the web user interface in
conjunction with a central provisioning method and phone user interface.
When configuring IP phones via web user interface, you require a user name and password for
access.
The default username/password is admin/123456.
1. Find the phone IP address. Press the OK key when the phone is idle for Halo series phones.
2. Enter the IP address in the address bar of a web browser on your PC.
For example, for IPv4: https://192.168.0.10; for IPv6: https://[2005:1:1:1:215:65ff:fe64:6e0a]
3. Enter the user name and password.
4. Click Login.
When you log into the web user interface successfully, the phone status is displayed on the first
page of the web user interface. You can click the navigation bar to customize or click Log Out to
log out of the web user interface.
The following figure is an example when you navigate to Features->General:
To Next Page
Loading...
