Alcatel-Lucent OmniPCX Office IP Touch 4068 Owner's Manual

Programming your telephone
30
8
8.14
Configuring the audio jack of your telephone
By default, the audio jack of your telephone can be used to connect a headset, handsfree kit or loudspeaker.
8.15
Activating/deactivating 'forced headset' mode
'Forced headset' mode must be activated as soon as a headset is installed instead of the receiver.
Reach the
'Menu' page
Settings
Set
Jack
Headset
OR
Hands-free
OR
Sta.speaker
Reach the
'Menu' page
Activating/deactivating 'forced headset' mode
Settings
Set
ForcedHead
On
OR
Off
8.16
Installing a Bluetooth® Wireless Technology handset (matching)
- Alcatel-Lucent IP Touch 4068 Phone
Reach the
'Menu' page
you will hear a 3 note signal and the
LED will flash green and orange
alternately
With the handset turned off,
press the 2 Bluetooth®
handset keys at the same time
(long press)
wait for the handset address and
name to be displayed on the screen
Select the
relevant
equipment
the 3 note audible signal indicates that the handset
has been installed correctly (the LED flashes green or
orange depending on the battery charge level)
If you add the Bluetooth® handset before the name of the handset is displayed on the
screen, you must enter the password 5555 to terminate the installation
Settings
Set
BlueTooth
Adddevices
Add
• Error messages
the Bluetooth® handset emits a
sequence of 4 beeps
The generation of your station is
earlier than the generation of your
Bluetooth® handset
The station displays an error
message indicating an
incompatibility between the
station and the Bluetooth®
handset
The generation of your
Bluetooth® handset is earlier than
the generation of your station

Alcatel-Lucent OmniPCX Office IP Touch 4068 Specifications

General

Brand	Alcatel-Lucent
Model	OmniPCX Office IP Touch 4068
Category	Telephone
Language	English