Alcatel-Lucent OmniPCX Office

processing is the same for a board in a "present but refused" state, but that board will not be
deactivated.
Note:
In case of a "gentle" plugging-in, it is possible that the plugged board may not be detected by the CPU
board or detected with the wrong slot number.
In online Mode, if OMC does not automatically detect a plugged/unplugged board on a powered-up
system, the session should be closed, then restarted for the board to be included.
3.1.4 Assigning Directory Numbers
At start up, a default telephone number is associated to each internal and virtual extension,
according to the default numbering plan and following the order of appearance of the
interfaces and their extensions:
The interfaces appear in the same order as the boards, so the order in which the system gives
a number to each interface is the following:
- The master cabinet extension board interfaces.
- The first satellite cabinet extension board interfaces if present.
- The second satellite cabinet extension board interfaces if present.
- The Mini-MIX daughter board interfaces if present.
- The virtual board interfaces (XRA, DECT, badge, IVPS, IP).
At the end of the start up, the next numbers are assigned to the sub-device extensions
according to their order of appearance.
The order of appearance is the same for every sub-device and the device to which it is
attached.
Example:
We have a system with 2 cabinets:
- a master cabinet with a 16UA extension board.
The UA set connected to the first interface has a V24 sub-device.
The UA set connected to the last interface also has a V24 sub-device.
2 IVPS ports.
- a satellite cabinet with a 16UA extension board.
The UA set connected to the first interface has a V24 sub-device.
After the system is started, 10 DECT handsets are added using MMC.
In the above configuration, and with a 3-digit numbering plan, the phone numbers are
assigned as follows:
- From 101 to 116 to the UA interfaces on the master cabinet.
- From 117 to 132 to the UA interfaces on the satellite cabinet.
- Numbers 133 and 134 to the IVPS ports.
- Numbers 135 and 136 to the V24 sub-devices on the master cabinet.
- Number 137 to the V24 sub-devices on the satellite cabinet.
- From 138 to 147 to the DECT handsets.
," *
 ! "#$ ! % $& !     
15/62