Type Message Location Additional Information Action
239 STORAGE MEMORY
CHANGED OR LOST
CPU (80) INFO 0 = type of error
- 0 : medium KO
- 1 : medium full
- 2 : checksum error
- 3 : system file control error
INFO 1 = type of medium
- 0 : NAND FLASH CPU
- 2 : HARD DISK
INFO 2 = type of initial medium
INFO 3 = affected memory area
(metering, alarms, voice prompts, etc)
242 ERROR ON OPENING
VOICE PROMPT FILE
CPU (80) INFO 0 to 3 = type and value of voice
prompt
243 ERROR ON CLOSING
VOICE PROMPT FILE
CPU (80) INFO 0 to 3 = type and value of voice
prompt
244 ERROR ON READING
VOICE PROMPT FILE
CPU (80) INFO 0 to 3 = type and value of voice
prompt
245 ERROR ON WRITING
VOICE PROMPT FILE
CPU (80) INFO 0 to 3 = type and value of voice
prompt
246 ERROR ON OPENING
VOICE PROMPT FILE
CPU (80) INFO 0 to 3 = type and value of voice
prompt
247 ERROR ON OPENING
VOICE PROMPT FILE
CPU (80) INFO 0 to 3 = type and value of voice
prompt
248 DISCHARGED BATTERY
OR BATTERY REPLACE-
MENT
This results in an incorrect
date/time
CPU (80)
249
6.4 History messages
The events identified by the codes in the system history messages table concern modifications
to the system hardware configuration (appearance/disappearance of boards or terminals,
refusal of a board on exceeding equipment limits) or other events (reset execution, buffer fill
rate attained, etc).
When the table is full, a new event is stored in place of the oldest message.
This table is only emptied in the event of a cold system reset.
Chapter
6
% *
28/62
! "#$ ! % $& !
To Next Page
Loading...
