a. Ensure that the mains power cable is NOT connected.
b. Ensure that the ON/OFF switch is set to the OFF position (O or black).
c. Ensure that the J1 jack is NOT connected to the OXO Connect Compact platform.
d. Open the unit by removing the four screws (ST3.5x32) with a screwdriver (Phillips PH2).
Mains power
connector
J1 jack
(for platform connection)
Power ON/OFF switch
4 screws
LED
2. Insert the batteries in the open unit as follows (see the figure below):
a. Place the first battery in the middle position (battery B1).
b. If a second battery is to be used, place this battery in the remaining position (battery B2).
Battery B2
Battery B1
3. Connect the negative (black) terminals of the batteries as described below (and shown in the figure
below).
a. Connect the middle connector of the black wire to the negative (black) terminal of battery B1.
b. If required, connect the end connector of the black wire to the negative (black) terminal of battery
B2.
Chapter
4
Installation and Cabling
3EH21123USAA - Ed. 01 - April 2017 - Installation Manual 69/207
To Next Page
Loading...
