What to do if the Diag LED is Red on my Alcatel OmniStack 6300-24?
If the Diag LED on your Alcatel Switch is red, begin by power cycling the switch to attempt to resolve the issue. If the red light persists after restarting the switch, it is recommended to contact your dealer for further assistance.
What to do if my Alcatel Switch has power problems and the power indicator doesn't turn on?
If the power indicator on your Alcatel Switch doesn't turn on, first check for any loose power connections. Also, check the power outlet for power losses or surges. Make sure that the fans on the unit are unobstructed and running before shutdown. If the problem persists, the internal power supply may be defective.
How to fix a Power LED that is Off on an Alcatel OmniStack 6300-24 Switch?
If the Power LED on your Alcatel Switch is off, check the connections between the switch, the power cord, and the wall outlet. If the issue persists, contact your dealer for assistance.
Why is the Link LED Off on my Alcatel OmniStack 6300-24 Switch and how to fix it?
If the Link LED on your Alcatel Switch is off, ensure that both the switch and the connected device are powered on. Verify that the cable is securely plugged into both the switch and the device. Confirm you're using the correct cable type and that it's not exceeding the specified length limits. Inspect the adapter on the connected device and the cable connections for any defects. If necessary, replace any defective adapters or cables.
What to do if I cannot connect to my Alcatel OmniStack 6300-24 using Telnet, Web browser, or SNMP software?
If you're unable to connect to your Alcatel Switch, ensure the agent is configured with a valid IP address, subnet mask, and default gateway. If connecting via the IP address for a tagged VLAN group, make sure your management station includes the appropriate tag in its transmitted frames. Verify you have a valid network connection to the switch and that the port being used is enabled. Check the network cabling between your management station and the switch. If using Telnet or SSH, you might have exceeded the maximum number of concurrent sessions; try again later.
What to do if I cannot access the on-board configuration program of my Alcatel OmniStack 6300-24 via a serial port connection?
If you're having trouble accessing the on-board configuration program of your Alcatel Switch via a serial port, ensure your terminal emulator program is set to VT100 compatible, with 8 data bits, 1 stop bit, no parity, and the baud rate set to 9600, 19200, 38400, 57600, or 115200 bps. Also, verify that the null-modem serial cable conforms to the pin-out connections specified in the Installation Guide.
General| Power over Ethernet (PoE) | No |
|---|---|
| Switching Capacity | 128 Gbps |
| Forwarding Rate | 95.2 Mpps |
| Operating Temperature | 0°C to 45°C |
| Storage Temperature | -40°C to 70°C |
| Manageable | Yes |
| Product Type | Switch |
| Ports | 24 |
| Uplink Ports | 4 |
| Layer | Layer 3 |
| MAC Address Table Size | 16000 entries |
| Jumbo Frame Support | Yes |
To Next Page
