When it is time to replace the batteries, will
flash on the display. You cannot take any further
measurements and must replace the batteries.
Replacing Batteries
To Replace the Batteries:
Turn the monitor upside down and remove
the battery compartment cover.
Remove the batteries and insert new bat-
teries.
Replace the battery compartment cover.
You may also operate this monitor using the AC
adapter (output 5V DC/1A with Micro USB plug).
Note: AC Adapter is not included in this prod-
uct. It is sold separately.
Use only the approved AC adapter to avoid dam-
aging the unit.
Ensure that the AC adapter and cable are not
damaged.
Plug the adapter cable into the AC adapter
port on the right side of the blood pressure
monitor.
Plug the adapter into your electrical outlet.
When the AC adapter is connected, no battery
current is consumed.
Using the AC Adapter
Note:
26
Use 4 new 1.5V AAA long-life, alkaline batter-
ies. If using reusable batteries, only use
“NiMH” reusable batteries.
Taking out the batteries will reset the date and
time but will not delete saved results. To reset
the date and time, see Setting the Date and
Time (page 14).
Do not use batteries beyond their expiration
date. If the monitor is not going to be used for
a prolonged period the batteries should be re-
moved.
Do not allow batteries to run out of charge in-
side the monitor. This will damage the moni-
tor. Always replace batteries once ap-
pears on the display.
If you do not intend to use the device for a
week or more, always remove or recharge bat-
teries!
1.
2.
3.
To Next Page
Loading...