10 11
LO
Less than 0.2‰BAC
LO
Less than 0.2‰BAC
Zero or Trace Alcohol
There is either no alcohol in the sample or such a
small amount it is negligible. The reading is well
below the legal drink drive limit.
Between 0.2‰BAC
and 0.3‰BAC
Between
0.2‰BAC and 0.5‰BAC
Low Levels
The sample has alcohol in it but it is below the
limit that has been set. Any amount of alcohol
affects your ability to drive.
Do not drive.
Between 0.3‰BAC
and 0.4‰BAC
(Hazard symbol will be
displayed on screen)
Between 0.6‰BAC and
0.7‰BAC
(Hazard symbol will be
displayed on screen)
Possibly Over the Limit
Taking into account environmental variables and
the accuracy of the unit you could be on or just
ov
er the limit. Do not drive.
Between 0.5‰BAC
and 1.5‰BAC
(Don’t drive symbol is
shown)
Between 0.8‰BAC and
1.5‰BAC
(Don’t drive symbol is
shown)
Over the Limit
The sample above the legal drink drive limit.
Do not drive.
Above 1.5‰BAC
(Don’t drive symbol is
shown)
Above 1.5‰BAC
(Don’t drive symbol is
shown)
The sample’s alcohol level is above 1.5‰BAC
and is outside the reading range of this
device. Do not drive.
Error in Reading Error in Reading
There has been an error while performing the
breath test. This is normally caused by either
blowing too hard or too softly into the
AlcoSense. See page 8, bullet point 4 or call us.
Example of Screen Example of ScreenDescription Description Explanation
On top of the unit there is a small sticker showing the alert level. Check
this then refer to the correct column and explanation for your device
below. Make sure you know the correct drink drive limit in your area.
0.5‰BAC Alert Level Model 0.8‰BAC Alert Level Model
IMPORTANT: The unit
is accurate to +/- 0.2‰BAC, therefore your reading
could be 0.2‰BAC higher than that shown on the screen. e.g. if your result was
0.6‰BAC, you could actually be 0.8‰BAC. Always take this into account.
To Next Page
Loading...
