Why is my Alderlea Wood stove not producing enough heat?
If your Alderlea Wood stove isn't producing enough heat, it could be due to several reasons. First, ensure you are using dry wood. Wet wood will significantly reduce heat output. Second, make sure you are building a large enough fire. Finally, a plugged or restricted chimney can also cause low heat output, so inspect and clean your chimney.
What to do if my Alderlea Wood stove won't burn overnight?
If your Alderlea Wood stove won't burn overnight, consider these potential causes. Your air control might be set too high; try setting it lower. You may not be using enough wood; unsplit wood is preferred for overnight burns. A draft that is too high, caused by excessive chimney height or diameter, can also be a factor. Also, ensure you're using good quality, dry wood.
Why Alderlea Wood stove wood won't burn?
If the wood in your Alderlea Wood stove isn't burning, it could be because the combustion air supply is blocked. Check the outside air supply for any obstructions. Another reason could be a low draft due to a chimney that is plugged or restricted; inspect and clean it. If these steps don't resolve the issue, consult your dealer, as the chimney may be oversized or otherwise unsuitable.
How to prevent excessive creosote buildup in my Alderlea Wood stove?
To prevent excessive creosote buildup in your Alderlea Wood stove, refer to the solutions for the following issues: using wet wood, turning down the air control too soon, and low draft.
Why is the glass on my Alderlea Stove getting dirty?
The glass on your Alderlea Stove might be getting dirty due to several reasons: using wet wood, turning down the air control or damper too soon (before a good bed of coals has formed and the wood is charred), having a draft that is too low (possibly due to improper chimney height or diameter), or a door gasket leakage. Make sure to use dry wood, wait until there is a good bed of coals and the wood is charred before turning down the air control, consult your dealer about chimney issues, and replace the gasket if it's leaking. Also, check the latch for proper operation.
What to do if my Alderlea Stove won't burn overnight?
If your Alderlea Stove isn't burning overnight, there are a few potential causes. The air control might be set too high, so try setting it lower. You might not be using enough wood; unsplit wood is better for overnight burns. A draft that's too high, possibly due to excessive chimney height or diameter, could also be the issue. Finally, the wood could be of poor quality or wet; make sure to use good quality, dry wood.
How to increase the heat output of my Alderlea T5?
If your Alderlea Stove isn't producing enough heat, the wood might be wet, so make sure to use dry wood. The fire might also be too small, so try building a larger fire. Additionally, the draft could be too low because the chimney is plugged or restricted; inspect and clean it.
What to do if the wood won't burn in my Alderlea T5 Stove?
If the wood in your Alderlea Stove won't burn, the combustion air supply might be blocked; check the outside air supply for any obstructions. Also, the draft could be too low because the chimney is plugged or restricted; inspect and clean it. For issues related to an oversized or unsuitable chimney, consult your dealer.
Explains how slow burning produces creosote and its condensation in the chimney flue.
Describes how excessive creosote buildup can cause a chimney fire.
Details minimum clearances to combustible surfaces for residential installations using single-wall connectors.
Step-by-step guide for connecting the stove to a chimney system.
Specifies minimum clearances to combustible materials for mobile home installations using double-wall connectors.
General advice on operating the stove for efficiency and safety.
Guidelines on selecting appropriate wood for burning, including what to avoid.
Guidance on setting air controls for efficient and safe continuous burning.
General| Type | Wood Stove |
|---|---|
| Burn Time | Up to 8 hours |
| Flue Size | 6 inches |
| EPA Certified | Yes |
| Heat Output | 65, 000 BTU |
| Log Size | Up to 20 inches |
| Heating Capacity | 2, 000 sq. ft. |
| Construction | Cast Iron |
To Next Page
