ALDI 4x4 TOUGH 22-72020 - Overview of LED Driving Lights & Light Bar Installation & Components

10
Battery(+)
connection
Battery(-)
connection
Fuse
12V RELAY
Red
Black
Black
A1. H4 Connector (or alternative connector)
A. Piggyback Cluster
B. Vehicle Highbeam Plug
A2. Connector to the LED wiring harness
A3. Connector to the vehicle wiring loom
C. 12 Volt Relay
D. In-line Fuse
E. Connector to H4 Cluster
F. Battery
G. LED Driving Lights & Light Bar
H. On / O Switch
I. Deutsch Splitter Cable Plug (x3)
J. Polycarbonate Lens Covers
F
D
E
FIREWALL
B
Run the dash rocker switch wiring
(H)from the relay through the
rewall and place the on/o
switch in a suitable position on
the dash board of your vehicle.
H
C
A1
A3
A2
A
From vehicle Wiring Loom
H4 OR HB3 PIGGYBACK ADAPTERS
HB3
H4
A2
A2
A1
A1
A3
A3
G
A
A
G
G
I
J
I
I
Overview of LED DRIVING LIGHTS & LIGHT BAR Installation & Components
24V Relay is also including in the kit
which can be used when installing
the LED Driving Lights on a vehicle
with a 24V operating system.
IMPORTANT! In the event the connectors
(A) are not compatible with your vehicle’s
connectors, we recommend going to an
authorised automotive electrician to
have a suitable connector for your
vehicle tted.