11
Troubleshooting
It is recommended to use a licensed automotive electrician if you are not familiar with
automotive electrical wiring.
If you choose to conduct the installation of the LED Driving
Lights & Light Bar please pay close attention to the installation instructions.
HOW TO REVERSE THE POLARITY IN THE CONNECTION TO THE
PIGGYBACK CLUSTER (E)
1.
Connector Plug (E) - with Black wire
on the top of the plug.
2. Connector Plug (E) - inside with flat
connectors.
3. With a small flat screwdriver push
the 2 retaining tabs downwards
inside the connector plug (E) to be
able to pull back the connectors.
4. Take the wires out and swap the
black and red wire over.
5. Using the small flat screw driver,
gently push the retaining tabs
sufficiently to ensure they lock
securely when reinserted into the
plug. Refer (E)
6. Push in the wires one by one with
Red positioned on top and Black
positioned on the bottom until you
hear a click.
CLEANING
Clean the LED Driving Lights and the LED Light bar with mild detergent applied with a non-abrasive
sponge or cloth.
MAINTENANCE AND SERVICING
Regularly inspect condition of the wiring and ensure the connectors are securely joined.
Keep the battery terminals clean and free from corrosion.
DISPOSAL - Check with your local council for recycling advice.
In the event the LED Driving Lights & Light Bar do not work, a common cause is
incompatible
polarity. This can be remedied by reversing the polarity as
illustrated in the instructions below.
To Next Page
Loading...