What to do if the sliding clamp rail (2) will not release from the end of the clamping jaws on ALDI 52539 Jawzilla?
If the sliding clamp rail won't release, the safety slider (3) likely hasn't engaged to release it. Push up the safety slider (3) to allow the sliding clamp rail to release from the end of the clamping jaws.
Why are the jaws locked in position on my ALDI 52539 Jawzilla?
The jaws might be locked because the clamping locking lever (11) is in the locked position. To unlock, push up the clamp locking lever (11) to the unlock position, then use your foot to push down on the clamp foot pedal (8) to release.
What to do if the front folding legs are not secure on ALDI 52539 Jawzilla Tools?
If the front folding legs aren't secure, it could be that the front leg locking knob (6) isn't engaged, or the ball bearing hasn't engaged in the front leg lock notch (10). Make sure the front leg locking knob (6) is engaged—you should hear a click when it locks. Also, check that the ball bearing engages in the front leg lock notch (10).
How to fix a moving rear folding leg on ALDI Tools?
If the rear folding leg is moving, the rear leg release knob (4) probably isn't tightened. Tighten the rear leg release knob (4) clockwise until it's fully secured.
To Next Page
General