EasyManua.ls Logo

ALDI 9113956 - Safety Instructions (Continued); General Injury Prevention; Material Damage Prevention; Charging the Shaver

ALDI 9113956
11 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8 AFTER SALES SUPPORT
www.aquarius-service.com
GB
IRE
00800-36 46 36 00
MODELL: 9113956 PRODUCT CODE: 91628 11/2014 Hotline free
AFTER SALES SUPPORT 9
GB
IRE
00800-36 46 36 00 www.aquarius-service.com
Hotline free MODELL: 9113956 PRODUCT CODE: 91628 11/2014
The shaver runs on 1 lithium-ion battery with overcharge protec-
tion. The battery can be charged without capacity loss and danger
of overcharging.
Please note that the battery capacity will decrease during extended
periods of storage. For this reason, long recharging times should be
avoided because of the interruption between the charging and
discharging cycles.
1. Place the shaver on a level surface.
2. Connect the wall power supply to the shaver.
3. Insert the wall power supply into an easily accessible power point.
4. The LCD lights up red, the plug symbol is permanently displayed
and the battery symbol fills. The LCD changes from red to blue if
10% charging capacity has been reached. The charging capacity is
further displayed in steps of 10%.
5. After a charging period of approx. 90 minutes, the battery has
reached its full capacity. The battery symbol is completely filled and
100% capacity displayed.
6. Once the batteries are fully charged, the shaver can be used in
battery mode for about 95 minutes.
7. Unplug the power cable from the power point and from the shaver
as soon as the batteries are fully recharged.
8. This shaver features a quick-charge function. It takes 5 minutes and
will last for a single shave.
9. If your shaver stops during shaving due to its batteries being
insufficiently charged, you can continue shaving by connecting it to
a power point.
WARNING! Risk of injury
Place the cable in such a way that no one trips over it or
steps on it!
Do not use the device on open wounds, cuts, sunburn or blisters.
Do not operate the shaver if the device or cutting elements are
damaged or defective.
The cutting blades are sharp. Handle with care.
Keep the shaver away from your eyes.
Always switch off the shaver before cleaning it.
CAUTION! Risk of material damage
Use the original accessories only.
Never place the shaver on hot surfaces (e.g. hob plates) or
near heat sources or open fire.
Do not cover the wall power supply to prevent overheating.
In order to avoid damages to the shaving foil, do not exert excessive
pressure on the shaving foil.
Do not use any harsh or abrasive cleaning agents.
NOTE: We advise you not to use shaving gel, since this may cause the
shaving foil and cutting blades to stick to each other.
04. Charging
NOTES:
Before first operation of the shaver in battery mode, you should
recharge the shaver for at least 90 minutes.
In order to maximise the battery life, you should allow the batteries
to completely discharge before recharging them.

Related product manuals