12 AFTER SALES SUPPORT
www.aquarius-service.com
GB
IRE
00800-36 46 36 00
MODELL: 9113956 PRODUCT CODE: 91628 11/2014 Hotline free
AFTER SALES SUPPORT 13
GB
IRE
00800-36 46 36 00 www.aquarius-service.com
Hotline free MODELL: 9113956 PRODUCT CODE: 91628 11/2014
07. Cleaning and Care
DANGER! Risk of injury and material damage
• Remove the wall power supply from the power point
before
cleaning the shaver.
• Never submerge the entire shaver in water.
Dry Cleaning
WARNING!
• Always switch off the shaver before cleaning it.
CAUTION! Risk of material damage
• Do not use any harsh or abrasive cleaning agents.
• Do not remove the shaving foil from the shaving foil frame
and do not clean it with the brush.
• The cutting blades must not be removed for cleaning pur-
poses. The springs located underneath the cutting blades
might jump out and get lost. Remove the cutting blades
for replacement purposes only (see "Replacing Parts",
page 15).
NOTE: Clean the shaver after every use to guarantee optimal results.
1. Press the lateral unlocking buttons (5) and remove the shaving foil
frame (3).
2. Tap out the shaving foil frame on an even surface and/or blow it out.
3. Press the lateral unlocking button (6); the shaving foil frame opens.
4. Use the cleaning brush to clean the cutting blades.
1. Take off the protective cap.
2. Push the hair trimmer upward.
3. Use the on / off switch
;
(7) to switch on the shaver.
4. After use, switch off the shaver, push the hair clipper into its basic
position and clean the shaver. (→ 7. Cleaning and Care)
Three-day stubble shave
1. You can use the 3-day stubble attachment (2) to trim your beard to
a hair length of 3 mm.
2. Place the beard attachment onto the shaving head so that it is
firmly attached to it.
3. Trim your beard as you would normally do when shaving.
NOTES:
Observe that the 3-day stubble attachment is intended only to limit
the beard hair growth to a length of 3 mm, and that it is not designed
to trim longer hair to 3 mm.
When using the 3-day stubble attachment, the direct contact of the
shaving foil to the skin is lost. Consequently, the shaving system is no
longer naturally “greased” by sebum.
4. To ensure constant shaving performance, apply a drop of blade or
sewing machine oil after wet cleaning. See section “Cleaning with
Water”.
To Next Page
Loading...
