14 AFTER SALES SUPPORT
www.aquarius-service.com
GB
IRE
00800-36 46 36 00
MODELL: 9113956 PRODUCT CODE: 91628 11/2014 Hotline free
AFTER SALES SUPPORT 15
GB
IRE
00800-36 46 36 00 www.aquarius-service.com
Hotline free MODELL: 9113956 PRODUCT CODE: 91628 11/2014
08. Replacement Parts
Cutting elements are subject to natural wear and excluded from the
warranty. For optimal shaving a replacement in good time is essential.
You are able to reorder the following replacement parts:
• 2 cutting blades
• Shaving foil (shaving foil frame with 2 shaving foils and integrated
hair clipper)
• Set containing the afore-mentioned replacement parts (shaving foil
and 2 cutting blades)
Recommended Replacement Intervals
We recommend replacing shaving foils once a year and the cutting
blades every 12–18 months to ensure an optimal shave.
Since both cutting elements adjust in time, it is recommended to
replace shaving foil and cutting blade simultaneously.
The replacement parts can be ordered via the Service Centre.
Replacing Parts
1. Take off the protective cap.
2. Press the unlocking buttons (5) and remove the shaving foil frame.
3. Grasp the old cutting blades at both ends between thumb and
index finger and pull them carefully off the shaver.
4. Take the new cutting blades at both ends between thumb and
index finger and push them into the white holding device. Press the
cutting blades completely and briefly down once until they audibly
lock into place.
5. Carefully press the new shaving foil frame into the shaving head
frame until it locks in place with an audible click.
Cleaning with water:
• You can comfortably clean the shav-
ing head of your shaver by rinsing
it under running water (see fig.).
1. Press the unlocking button (6); the shaving
head frame opens.
2. Hold the appliance so that the cutting blades
point down at an angle. The risk of water
entering the inside of the appliance will thus
be reduced.
The water temperature should not exceed
70 °C.
3. If you prefer rinsing the appliance under running water, you may
also add a few drops of usual liquid soap. To achieve more intense
cleaning results, switch the appliance on.
CAUTION! The housing may be cleaned with a damp cloth;
however, the shaver must not be immersed in water!
4. Allow the shaver to dry before closing the shaving head frame and
reattaching the protective cap.
5. The shaving head frame must be touched on the sides only and
pressed down until the fixing clips lock in place.
CAUTION! Do not use force and do not apply pressure on the
shaving foil!
NOTE: From time to time, place a few drops of acid-free oil (such as
sewing machine oil) onto the cutting blades and the hair clipper. Let
the device run for a couple of seconds without using it. Using a soft
cloth, wipe off the surplus oil, if necessary.
To Next Page
Loading...
