AFTER SALES SUPPORT
1 800 898 750
Aus
Aldi.aftersales@axima.com.au CPL-2054
Operation
07
3.1 Operation
The car battery charger CPL-2054 automatically
recognises the connected type of battery (6 V-or
12 V battery).
If the battery terminals are connected incorrectly
(polarity reversal), the red fault light will light up
immediately .
In the event of overheating or a short-circuit
during operation, the red fault light also lights up.
The charger reverts to standby mode.
Charging only commences once a program has
been selected with the MODE key. If the charger
is connected to a 6 V battery, only the 6V program
can be activated via the MODE key. Other settings
are not possible. If the charger is connected to a
12 V battery, the MODE key allows the selection of
programs , and .
During charging, the displays shows the selected
charging program, the current battery voltage,
the charging status and the charging process by
the number of bars in the battery symbol and the
ashing frame of the battery symbol.
3.2 Connecting the charger
Caution
Always ensure that you connect the battery to the charger before connec-
ting the mains plug.
Caution
Explosion hazard due to gas. Highly explosive gas can be produced during
charging of lead-acid batteries. Only charge batteries in well ventilated
areas.
3
,
To Next Page
Loading...
Need help?
General