Operation
26
6 V / 0.8A charging mode (6V batteries up to max. 14Ah)
You can identify the battery type from the type plate on your battery.
Observe the battery charging recommendations.
The charger will normally recognise the 6V standard charging mode suitable for the
battery type. If the battery is not recognised, proceed as follows:
− Set this mode to charge 6V batteries with a capacity under 14Ah.
− Press the MODE
1
button several times to select 6 V / 0.8.
The
12
symbol is shown on the display
2
.
If you do not then set another mode, the electronics automatically start the charging
process with a charging current of around 0.8A.
Once the battery is fully charged, the frame around the battery icon
13
stops fl ashing
and the entire battery symbol lights up continuously. Trickle charging takes place in
this state.
12 V / 0.8A charging mode (12 V batteries up to max.
120Ah)
You can identify the battery type from the type plate on your battery.
Observe the battery charging recommendations.
The charger will normally recognise the 12V standard charging mode suitable for the
battery type. If the battery is not recognised, proceed as follows:
− Set this mode to charge batteries with a capacity under 120Ah.
− Press the MODE button
1
several times to select 12 V / 0.8 A.
The
9
and
10
symbols are shown on the display
2
.
If you do not then set another mode, the electronics automatically start the charging
process with a charging current of around 0.8A.
Once the battery is fully charged, the frame around the battery icon
13
stops fl ashing
and the entire battery symbol lights up continuously. Trickle charging takes place in
this state.