Operation
28
12V / 5 A charging mode (rapid charging for 12 V batteries
from 1.2Ah to 120Ah)
You can identify the battery type from the type plate on your battery.
Observe the battery charging recommendations.
Proceed as follows:
− Set this mode to charge batteries with a capacity of 1.2Ah and over and normal
ambient temperatures.
− Press the MODE button
1
several times to select 12 V / 5 A mode.
The
10
symbol is shown on the display
2
.
If you do not then set another mode, the electronics automatically start the charging
process with a charging current of around 5 A.
Once the battery is fully charged, the frame around the battery icon
13
stops fl ashing
and the entire battery symbol lights up continuously. Trickle charging takes place in
this state.
12 V / 5 A / Cold (charging process for 12V batteries, from
1.2Ah to 120 Ah, at low temperatures)
You can identify the battery type from the type plate on your battery.
Observe the battery charging recommendations.
Proceed as follows:
− Set this mode to charge batteries with a capacity of 1.2Ah and over and low
ambient temperatures. Set this mode also to charge suitable gel and AGM
batteries (absorbent glass mat: batteries in which the electrolyte is held in glass
fi bre mats) with a capacity of 1.2Ah and over.
− Press the MODE button
1
several times to select
12 V / 5 A / COLD mode.
The
11
symbol is displayed.
If you do not then set another mode, the electronics automatically start the charging
process with a charging current of around 5 A.
Once the battery is fully charged, the frame around the battery icon
13
stops fl ashing
and the entire battery symbol lights up continuously. Trickle charging takes place in
this state.