Operation
17
9. Remove the rechargeable battery from the product.
10. If necessary, pull the screwdriver bit out of the drill bit adapter.
11. Rotate the quick-action drill chuck anticlockwise until you can pull out the screw-
driver bit or the drill bit adapter from the quick-action drill chuck.
12. Pull the locking mechanism of the SDS-Plus shank holder on the product as far
back as possible in order to pull out the quick-action drill chuck from the SDS-Plus
shank holder.
Using the rechargeable battery
WARNING!
Risk of injury!
Incorrect use of the rechargeable battery and charger can cause injury.
− This product does not come supplied with a battery. Only use the re-
chargeable batteries specified in the chapter ‘Technical data’ for the prod-
uct. Do not operate the product with rechargeable batteries from other
manufacturers.
− Read and follow the instructions in the user manual for the battery pack
and charger used.
Charging the rechargeable battery
− To charge the battery, follow the instructions described in the user manual for the
battery pack and charger used.
Inserting and removing the battery
− To insert the rechargeable battery, slide it into the rechargeable battery holder
5
(see Fig.A). The battery audibly locks into place.
− To remove the rechargeable battery, press the battery-release button and pull
the rechargeable battery out of the battery holder.
WARNING!
Risk of accident and injury!
There is a risk of accident and injury in the event of accidental activation of the
On/Off switch when inserting and removing fitted tools, when making adjust-
ments to the product, and when transporting and cleaning the product.
To Next Page
Loading...
