22
AUS
Attachment and operation
To empty the bag:
• Switch the engine off.
• Open the zipper and empty the bag without disconnecting it from the fitting tube.
• IMPORTANT When used as a vacuum collector do not collect damp grass or leaves to
avoid clogging the rotor and bag.
IMPORTANT: When using the machine as a vacuum collector, there is a risk of inad-
vertently suctioning objects which can obstruct the machine and block the rotor.
In this case:
• Switch the motor off immediately - remove the spark plug cap.
• Disassemble the vacuum tube.
• Remove the foreign body from inside the vacuum inlet.
• Check that nothing is blocking the rotor before using the machine again.
IMPORTANT: A too full bag reduces the machine‘s efficiency and could cause the
engine to over heat.
End of operations
When you have finished your work:
• Switch off the engine as indicated above.
• Empty the bag if used as a vacuum collector.
• If the rotor blocks, please follow the instructions as explained above.
Tuning idle speed (Fig. 5)
Idling must be adjusted when the engine tends to turn off or no significant speed differ-
ences are noted when using the throttle.
Adjustment is performed after starting the engine and letting it run idle for several min-
utes, using the screw (D):
• Turn clockwise to increase engine rpm;
• Turn counter-clockwise to decrease engine rpm.
After adjusting, the engine should idle without irregularities or pauses.
Stopping the engine
Emergency Stopping Procedure:
• When it is necessary to stop blower engine immediately, DEPRESS the switch to OFF.
Normal procedure:
• To stop the motor, push back the throttle lever lock, so that the motor runs in idling
mode. Finally move the ON/OFF switch to “OFF”.
To Next Page
Loading...