23
VIII. Working instructions
Operation
• Do not smoke while refuelling or operating equipment.
• Do not touch or let your hands or body come in contact with a hot muffler or spark
plug wire.
• Due to the danger of exhaust fumes, never operate blower in a confined or poorly
ventilated area.
• Use the tool only in broad daylight or in well-lit conditions.
• Do not underestimate the forces involved. Make sure you stand squarely and keep
your balance at all times.
• If possible, avoid using the tool on wet grass.
• Ensure that you maintain a steady foothold particularly while working on slopes.
• Always walk. Never run.
• Always keep the ventilation opening clean.
• Never direct the blow hole at persons or animals.
• The machine may only be used at reasonable times of the day, i.e. not in the early
morning or late evening when it will be a nuisance to other people. Permitted times
of use specified by local authorities must be observed.
• The machine must be run at the lowest possible motor speed required to carry out
the work.
• Remove all foreign objects with a rake and brush before starting any blowing work.
• Where conditions are dusty, dampen the surface a little or use a sprinkler attachment.
• Use the full-length blower nozzle extension so that the air current can work near to
the ground.
• Watch out for children, pets, open windows etc. and blow the foreign objects safely
away from them.
• If the device makes abnormal noises or has unusually high levels of vibration, it must
be checked. Unusually high levels of vibration can injure the operator and damage
the unit.
• Never operate the appliance with defective guards or shields, or without safety de-
vices, for example debris collector in place
• Do not expose the hot engine to flammable materials
• The Blower can be used to blow debris from patios, paths, driveways, lawns, bush-
es and borders.
Blower and vac mode
• Select the blow function using the selector lever on the side of the machine and
switch on.
• Alternatively hold nozzle just above the ground and swing the machine from side to
side, moving forwards and direct the nozzle at the debris to be cleared.
• Blow the debris into a convenient heap.
AUS
Working instructions
To Next Page
Loading...