First use
10
First use
Checking the product and scope of delivery
NOTICE!
Risk of damage!
If you are not cautious when opening the packaging with a sharp
knife or other pointed object, you may quickly damage the product.
− For this reason, be very careful when opening it.
1. Take the product out of the packaging.
2. Check to make sure that all parts are included (see Fig. A).
3. Check whether the product or individual parts are damaged. If this is the case, do
not use the product. Contact the manufacturer via the service address indicated
on the warranty card.
Basic cleaning
1. Remove the packaging material and all plastic wrappings.
2. Clean all parts of the product before first use as described in the chapter
“Cleaning”.
Using the product
1. Insert the base stand
4
, upper stand
2
, lower stand
3
and stand
support
1
onto each other (see step 1 in Fig. B).
2. Place the jug
5
, small bowls
6
and large bowl
7
on the assembled stand
(see step 2 in Fig. B).
3. Attach the bung
8
onto the upper end of the hose
10
and then insert the bung
and hose into the opening at the bottom of the jug (see step 1 in Fig. C).
4. Attach the lower end of the hose to the water outlet
11
of the pump
12
(see step 2 in Fig. C).
5. Place the pump at the bottom of the large bowl and secure the pump with its
suction feet.
6. Attach the hose to the stand with the clips
9
. Close the clips to secure the fixing
(see Fig. D).
To Next Page
Loading...
